heat of mixing

英 [hiːt ɒv ˈmɪksɪŋ] 美 [hiːt əv ˈmɪksɪŋ]

混合热

化学



双语例句

  1. It also listed heating effect of Xinhua heat supply company of Mudanjiang which proved the energy saving effect of mixing water heating system.
    并列举了牡丹江新华供热公司在使用中的效果,更加证明了混水直连供热系统在运用中的节能效果。
  2. Study on Hydrodynamics and Enhanced Heat Transfer Performance of GK-type Static Mixing Elements
    GK型静态混合元件的流体力学和强化传热性能研究
  3. When the LPG alternating ratio is smaller, the ignition delay of pre-mixing model is longer, and the peak cylinder pressure and heat release rate are higher than those of mixing injection model, and their corresponding crank angles retard.
    LPG替代率较小时,预混进气方式与混合喷射方式相比滞燃期较长,最高爆发压力和最大燃烧放热率较低,对应的曲轴转角滞后;
  4. Determination of the Heat of Mixing in Solutions& A New Calorimeter
    溶液混合热的测定&卡计的研制
  5. Thermal conductivity is important thermal parameter, symbols the ability of heat exchanging. Design and Improvement of Mixing Ion Exchanging of Demineralized Water Station of Thermal Power Plant
    导热系数是液体的重要热物性参数,其表征流体的热传导能力。热电厂二级脱盐水站混合离子交换的设计与改进
  6. Al-based amorphous alloys appear that a multicomponent combination of constituents with large atomic size differences ( i.e> 12%) and a negative heat of mixing are key factors favoring galss formation.
    铝基非晶合金由于多组元,原子之间较大的尺寸差(ie>12%)以及原子之间大的负混合热而具有强的非晶形成能力。
  7. This paper proceeding from actual application briefly analyzes a new type of water& water mixing heat exchanger and compares it with other types of mixing heat exchanger.
    本文从应用角度出发,对轴向水-水混合式加热器的实用性进行了分析,并与数种其他加热器进行了技术性能比较。
  8. Because of the molecular association, many properties of solution are changed such as microstructure, excess volume, heat of mixing, spectroscopic property and so on.
    缔合作用的存在使得溶液的微观结构发生了变化,从而导致了溶液宏观性质如过量体积、混合热、波谱性质等的变化。
  9. The relationship between gelation rate and membrane structure was characterized by the parameters of average gelation rate constant, coagulation value, heat of mixing of solvent and gelation medium, and surface tension.
    还采用了平均凝胶速度常数、絮凝值、混合热、表面张力等参数来表征凝胶速度与膜结构的相关性,为预测可能生成的膜结构提供了重要信息。
  10. The experimental methods contain Optical and Electron Microscopy, Light Scattering, X-ray Scattering, Neutron Scattering, Measurements of Glass Transition Temperature, Melting Point Depression, Heat of Mixing Measurements, Inverse Gas Chromatography, Infra-Red Spectroscopy, Excimer Fluorescence, Nuclear Magnetic Resonance etc.
    实验方法涉及电子和光学显微镜法,光散射法,X光散射法,中子散射法,玻璃化温度评价,熔点降低法,量热法,反相气体色谱,红外吸收光谱,荧光光谱和核磁共振等方法。
  11. Apparatus to measure the specific heat capacity of solids by mixing method
    混合法测固体比热容仪器的研制
  12. The calculation of vapor-liquid equilibria of benzene-acetone and toluene-acetonitrile systems from isothermal binary heat of mixing data is presented. The agreement between the calculated and experimental values of vapor composition is rather well.
    从苯丙酮和甲苯乙腈两体系的等温混合热计算了汽液平衡,汽相组成的计算值和实验值间的符合程度是满意的。
  13. Effect of heat of mixing on formation and stability of Zr-base metallic glasses
    混合热对Zr基金属玻璃体形成和稳定性的影响
  14. The Mutual Prediction Between Heat of Mixing and Vapor-liquid Equilibria Data
    混合热和汽液平衡数据间的相互推算
  15. This paper mainly described the affection imposed to mixing by temperature, the reasons, which caused heat in the process of mixing, and the factors. that affects the discharge temperature.
    主要论述了密炼机混炼过程中温度对混炼的影响,热量产生的原因,以及影响排胶温度的因素等问题。
  16. This model was applied for mixing heat and nonpolar compounds, the average errors of mixing heat were lower than 7%.
    该模型用于非极性-非极性、极性-非极性、极性-极性共10个有代表性体系作混合热关联计算,其平均误差小于7%。
  17. In order to obtain supreme economic results for heat exchanger to recover waste heat, this paper deduces the calculation formulae of optimal component efficiency, optimal heat transfer area and optimal heat-exchanging temperature of n-pass A unmixing and B mixing cross flow heat exchanger.
    基于热交换器回收余热取得最大经济效益出发,导出了n行程A不混合B混合叉流热交换器的最佳分效率、最佳换热面积和最佳换热温度计算公式。
  18. Investigation of Relationship Between Heat of Mixing aud Vapor-Liquid Equilibrium for Binary Aqueous Solutions of Glycols
    二元系多甘醇水溶液的混合热与汽液平衡关系的研究
  19. The calculation of partial radial distribution function of ions, heat of mixing and potential energy distribution shows that the average distance between Li~+ and F~-ions will significantly narrow after molten LiF and KF mix up.
    对各离子间的偏径向分布函数和混合热、位能分布等的计算表明,LiF与KF熔盐混合后,Li~+,F~-离子间平均距离减少,与互易盐系LiF-KCl溶液的模拟结果相似。
  20. In oil gas gathering process of tree type double pipes mixing heat water, energy consuming of system is related to quantity and temperature of mixing water, diameter of pipes, output of wells, ratio of water in oil, viscosity of liquid transfered.
    树状双管掺热水集输流程中,系统能耗与掺水量、掺水温度、管径、油井产液量、含水率、输送介质粘度等因素有关。
  21. Heat Transfer Augmentation of Viscous Fluid by Means of a π-type Static Mixing Element
    π型静态混合元件强化粘性流体传热的研究
  22. The methods of mutual prediction between heat of mixing and vapor-liquid equilibria data are reviewed.
    本文评述了混合热和汽液平衡数据间相互推算的方法。
  23. During the disposal of waste water in the recycle device of acrylic fibre solvent, for a good deal of heat of solution produced by mixing oil of vitriol with water, the cauterization is rigorous, the line is rusted and leaked frequently.
    腈纶溶剂回收装置的污水处理过程中,由于浓硫酸与水混合后产生大量的热,腐蚀条件极为苛刻,管线腐蚀泄漏频繁,影响正常生产。
  24. The Radiant Heat Transfer Equation of the Mixing Burning Boiler Furnace of Grate and Pulverized Coal
    链条炉炉膛加煤粉复合燃烧的辐射换热计算
  25. The effects of the common additional elements on the microstructure, properties and the processes of Nd-Fe-B magnets are discussed in this work by referring the heat of mixing and the binary diagrams.
    参考热力学,系统讨论了各种常用添加元素对烧结Nd-Fe-B的微结构、性能和制造工艺的影响。
  26. Heat release rules of LPG/ diesel mixing fuel engine
    LPG/柴油混合燃料发动机的放热规律
  27. Develops the non-linear dynamic model for a mixing water district heating system. Analyses dynamic characteristics of the system and the influences of pipe heat loss, ratio of makeup water, ratio of mixing water, solar radiation and internal heat gains on indoor air temperature.
    建立了某区域供暖系统的动态模型,分析了系统的动态特性及散热损失、补水率、混水比、太阳辐射及室内得热量对室内温度的影响。
  28. Gas-solid fluidized bed with a high mass transfer efficiency of heat transfer, particles tend to advantages of mixing and suitable for large scale continuous production, and therefore is widely used in process industry.
    气固流化床具有传质传热效率高、颗粒易于混合均匀和适合大规模连续化生产等优点,因而被广泛应用于过程工业中。
  29. The influence of rotate speed and filling rate on the heat transfer time of mixing oil shale and solid heat carrier and temperature distribution uniformity among particles has been conducted.
    模拟研究了干馏炉转速和物料填充率对于油页岩与固体热载体间混合时间以及颗粒间温度分布均匀性的影响。